kenmore 25378106890 manual troubleshooting

The Kenmore 25378106890 is a refrigerator model. Below are key sections for safety, features, installation, setup, operation, and troubleshooting. This guide focuses on identifying and resolving common issues to ensure optimal performance.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Care & Cleaning 8. Regulatory Information 9. Troubleshooting

Features at a Glance

Key components: Refrigerator and freezer compartments, temperature controls, ice maker, water dispenser, door bins, and adjustable shelves.

FeatureDescription
Refrigerator CompartmentAdjustable temperature control for fresh food storage
Freezer CompartmentSeparate temperature control for frozen items
Ice MakerAutomatic ice production (on select models)
Water DispenserProvides chilled water (on select models)
Adjustable ShelvesFlexible storage options
Crisper DrawersHumidity-controlled for fruits and vegetables
Door BinsStorage for frequently used items
Energy Saver SwitchReduces energy consumption
Temperature AlarmAlerts if temperatures rise above safe levels
Power CordStandard 120V AC plug

Installation

Unpack and inspect contents. Place on level floor in well-ventilated area.

  1. Remove all packaging materials and tape.
  2. Ensure unit is level using adjustable front feet.
  3. Allow at least 2 inches of clearance on all sides for proper airflow.
  4. Plug into a dedicated 120V AC, 60Hz outlet.
  5. Allow refrigerator to run for 24 hours before adding food.

WARNING! Refrigerator is heavy; use caution when moving. Ensure the floor can support the weight.

First-Time Setup

After installation, configure settings for optimal operation.

  1. Set temperatures: Recommended settings are 37°F for refrigerator and 0°F for freezer.
  2. Activate ice maker (if equipped): Lower the wire signal arm to begin ice production.
  3. Check water connection (if equipped): Ensure water line is connected and not kinked.
  4. Adjust shelves and bins to suit storage needs.

CAUTION! Do not overload shelves. Distribute weight evenly.

Specifications

Controls and Settings

Temperature controls are typically located inside the refrigerator compartment.

Refrigerator Control: Dial or digital setting to adjust cooling level (1-9 or Cold-Colder). Freezer Control: Separate dial or setting. Energy Saver Switch: Reduces condensation. Ice Maker On/Off: Arm or switch to control ice production.

For models with digital displays: Use touch pads or buttons to set exact temperatures. Refer to control panel labels for specific functions.

Connecting Devices

This section primarily applies to ice maker and water dispenser connections.

  1. Water Line Connection: Shut off main water supply. Connect approved water line to refrigerator inlet valve and water source.
  2. Ice Maker: Ensure ice maker is properly installed in freezer compartment.
  3. Electrical: Plug power cord into grounded outlet. Do not use an extension cord.

Tip: Ensure all connections are secure and leak-free before turning on water supply.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and warm water. Do not use abrasive cleaners.

Exterior: Wipe with soft cloth. Interior: Remove shelves and bins to clean separately. Condenser Coils: Vacuum every 6-12 months to maintain efficiency.

CAUTION! Never use harsh chemicals, scouring pads, or excessive water on controls or electrical parts.

Regulatory Information

This appliance complies with FCC Part 15 for unintentional radiators. Manufactured under license. Kenmore is a registered trademark. For support, visit www.kenmore.com or contact 1-800-253-1301.

Troubleshooting

SymptomPossible CauseCorrective Action
Refrigerator not coolingPower issue, dirty coils, control settingEnsure unit is plugged in and outlet works. Check temperature settings. Clean condenser coils.
Freezer too warmOverloaded, door not sealing, frost buildupDo not block air vents. Ensure door seals clean and tight. Defrost if needed.
Excessive frost in freezerDoor left open, faulty seal, defrost systemCheck door seal for gaps. Ensure door closes completely. May require service for defrost system.
Water dispenser not workingWater supply off, clogged filter, kinked lineTurn on water supply. Replace water filter (if equipped). Check for kinks in line.
Ice maker not producing iceSwitch off, water supply, clogged filterEnsure ice maker arm is in down position. Check water supply and filter. Allow 24 hours for initial production.
Unusual noiseUnit not level, items touching back wall, fan obstructionLevel the refrigerator. Rearrange contents so nothing touches back wall. Check for obstructions in fan.
Water leaking on floorClogged defrost drain, loose water connectionClear defrost drain tube. Check water line connections for leaks.
Interior lights not workingBulb burned out, door switch faultyReplace bulb. Check door switch operation.

Reset: Unplug refrigerator for 5 minutes, then plug back in to reset control board.

Service: 1-800-253-1301; www.kenmore.com

Kenmore 25378106890 Manual Troubleshooting © - All Rights Reserved 2025