Kenmore 795 Refrigerator Service Manual

The Kenmore 795 Refrigerator is a side-by-side model featuring advanced temperature control, ice and water dispensers, adjustable shelving, and energy-efficient operation. This service manual provides comprehensive information for installation, operation, maintenance, troubleshooting, and repair. Below are key sections covering safety, features, installation, operation, maintenance, and technical specifications.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water Supply 7. Operation 8. Maintenance & Cleaning 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Side-by-side design, Ice and water dispenser, Adjustable glass shelves, Humidity-controlled crispers, Freezer baskets, Temperature control panel, Water filter.

FeatureDescription
Ice MakerAutomatic ice production with adjustable cube size
Water DispenserChilled water with filter indicator
Adjustable ShelvesTempered glass shelves for flexible storage
CrispersHumidity-controlled for produce freshness
Freezer BasketsSlide-out baskets for organized storage
Temperature ControlDigital display with separate fridge/freezer settings
Door AlarmAudible alert if door left open
Energy SaverSwitch to reduce energy consumption
Power CordStandard 120V AC connection
Leveling LegsAdjustable for stability on uneven floors

Installation

Unpack and inspect contents. Position refrigerator in desired location.

  1. Remove packaging: Remove all tape, foam, and protective film.
  2. Level the refrigerator: Adjust front leveling legs using wrench.
  3. Connect water supply: Attach water line to cold water valve (if using dispenser).
  4. Plug into AC power: Use dedicated 120V, 15-amp outlet.
  5. Allow stabilization: Let refrigerator stand upright for 2 hours before powering on.

WARNING! Refrigerator is heavy; use two people for moving. Ensure proper clearance from walls (minimum 2 inches).

First-Time Setup

Power on refrigerator; follow initial setup steps.

  1. Set temperature: Press TEMP buttons to set fridge (37°F recommended) and freezer (0°F recommended).
  2. Activate ice maker: Lift wire arm to ON position.
  3. Prime water system: Dispense water for 3 minutes to clear air from lines.
  4. Set door alarm: Enable/disable via control panel.
  5. Reset filter indicator: Hold FILTER button for 3 seconds after replacing filter.

CAUTION! Do not load food until temperature indicators show proper cooling.

Specifications

Controls and Settings

Control Panel: TEMP (fridge/freezer), ICE TYPE (cube/crushed), FILTER RESET, DOOR ALARM, ENERGY SAVER, LOCK.

Temperature Settings: Fridge: 34°F to 46°F; Freezer: -5°F to 5°F.

Ice Maker: ON/OFF arm, cube size selection. Water Filter: Indicator light turns red when replacement needed. Door Alarm: Sounds after 3 minutes if door ajar. Energy Saver: Reduces condensation in humid environments. Control Lock: Prevents accidental setting changes.

Connecting Water Supply

Required for ice maker and water dispenser operation.

  1. Turn off main water supply.
  2. Connect 1/4" copper or plastic water line to cold water valve.
  3. Route line to refrigerator connection port (rear bottom).
  4. Secure with compression fitting.
  5. Turn water on and check for leaks.
  6. Install water filter (push and twist clockwise).

Tip: Use manufacturer-approved water line. Flush system before first use.

Operation

Daily use guidelines for optimal performance.

  1. Loading food: Allow hot food to cool before placing in refrigerator.
  2. Organizing shelves: Place dairy on upper shelves, meats on lower shelves.
  3. Using crispers: Set humidity control based on contents (high for veggies, low for fruits).
  4. Ice dispensing: Press glass against paddle for ice, hold for crushed.
  5. Water dispensing: Press and hold glass against paddle for water.
  6. Changing filter: Turn filter counterclockwise, remove, insert new filter, turn clockwise.
  7. Vacation mode: Set fridge to 45°F and freezer to 5°F if away for extended period.

WARNING! Do not block air vents inside compartments. Keep door seals clean.

Maintenance & Cleaning

Unplug before cleaning interior components.

  1. Interior: Clean with solution of baking soda and warm water.
  2. Shelves and bins: Remove and wash with mild detergent.
  3. Door seals: Wipe with damp cloth to maintain seal.
  4. Condenser coils: Vacuum every 6 months (located at back or bottom).
  5. Exterior: Clean with mild soap and water; stainless steel models use appropriate cleaner.
  6. Ice maker: Empty and clean ice bin monthly.
  7. Water system: Sanitize annually using manufacturer instructions.

CAUTION! Do not use abrasive cleaners or sharp objects. Never pour water over control panel.

Regulatory Information

UL Listed: Complies with UL Standard 250. Energy Star: Meets ENERGY STAR® requirements for energy efficiency. FCC Part 15: Class B digital device. Copyright © 2025 Kenmore; trademarks of Sears Brands, LLC. For support, visit www.kenmore.com or contact 1-800-469-4663.

Troubleshooting

SymptomPossible CauseCorrective Action
Refrigerator not coolingPower/thermostatCheck power connection; ensure thermostat set correctly; clean condenser coils.
Ice maker not workingWater supply/arm positionEnsure water line connected; check that arm is in ON position; replace water filter.
Water dispenser slowFilter/clogReplace water filter; check for kinks in water line.
Excessive frost in freezerDoor seal/defrost systemCheck door seal for gaps; ensure defrost system functioning.
Unusual noisesLeveling/fanLevel refrigerator; check for objects touching fan blades.
Water leakageConnection/clogged drainTighten water line connections; clear defrost drain tube.
Control panel unresponsivePower/lockCheck power; disable control lock (hold LOCK for 3 seconds).

Reset: Unplug for 5 minutes, then reconnect to reset electronic controls.

Service: 1-800-469-4663; www.kenmore.com

Kenmore 795 Refrigerator Service Manual © - All Rights Reserved 2025