Kenmore Dishwasher User Manual

The Kenmore Dishwasher is a high-performance kitchen appliance designed for efficient cleaning and sanitizing of dishes, glassware, and utensils. It features multiple wash cycles, adjustable racks, energy-saving options, soil sensors, delay start, and quiet operation. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Control Panel, Upper and Lower Racks, Silverware Basket, Filter System, Spray Arms, Detergent Dispenser, Rinse Aid Dispenser.

Installation

Unpack and inspect contents. Ensure proper location near water supply, drain, and power source.

1. Connect water supply: Attach hot water line (minimum 120°F/49°C) to inlet valve.
2. Connect drain hose: Ensure proper loop to prevent backflow into dishwasher.
3. Electrical connection: Plug into grounded 120V, 60Hz outlet (dedicated circuit recommended).
4. Level the dishwasher: Adjust leveling legs to ensure unit is stable and door seals properly.
5. Secure to countertop: Use mounting brackets to prevent tipping.

WARNING! Installation should be performed by a qualified technician. Ensure water and electrical connections are secure to prevent leaks or electrical hazards.

First-Time Setup

Before first use, run a rinse cycle to clean interior.

1. Remove shipping materials: Check interior for foam blocks or tape and remove.
2. Load detergent: Fill main detergent cup with dishwasher detergent (powder, gel, or tablet).
3. Fill rinse aid: Open rinse aid dispenser and fill to MAX line.
4. Select cycle: Choose Normal cycle and press Start.
5. Set preferences: Use control panel to set default options like sound volume, cycle end signal.

CAUTION! Do not use regular dish soap. Use only detergents specifically designed for dishwashers.

Specifications

• Capacity: Standard 12-14 place settings.
• Dimensions: 24 inches wide, 24 inches deep, 35 inches high (standard under-counter).
• Water Consumption: 3-6 gallons per cycle (varies by cycle).
• Power Requirements: 120V AC, 60Hz, 15 Amp dedicated circuit.
• Noise Level: 48-55 dBA (Quiet Series models).
• Wash Cycles: Normal (2 hours), Heavy (3 hours), Light (1 hour), Rinse Only (15 min).
• Drying System: Condensation drying or heated drying.
• Filter Type:Hard Food Disposer or Manual Clean Filter. Water TemperatureRequires 120°F minimum for optimal cleaning Warranty1-year limited warranty on parts and labor

  Controls and Settings

  Access controls via front panel buttons or touch display. Control Panel: POWER, CYCLE SELECTION, OPTIONS, START/RESET, DELAY START, CHILD LOCK.

  Cycle Options: NORMAL - for everyday loads; HEAVY - for pots/pans; LIGHT - for lightly soiled; RINSE ONLY - for rinsing without detergent; SANITIZE - uses high temp for sanitization.

  Additional Settings: HEATED DRY - uses heating element; ENERGY SAVER DRY - uses residual heat; DELAY START - delays cycle start 1-24 hours; SOIL LEVEL - adjusts wash intensity; SOUND - turns cycle end signal on/off.

  Loading the Dishwasher

  Proper loading ensures optimal cleaning and prevents damage.

  1. Scrape off large food particles; no pre-rinsing required for most cycles.
  2. Lower rack: Place plates, pots, pans, and larger items facing center.
  3. Upper rack: Place cups, glasses, bowls, and plastic items.
  4. Silverware basket: Mix utensils (some up, some down) to prevent nesting.
  5. Adjust upper rack: Raise/lower to accommodate tall items on lower rack.
  6. Ensure items don't block spray arms or detergent dispenser.

  Tip: Load similar items together (all plates in one section) for better water flow.

  Using Detergents & Rinse Aids

  Use only dishwasher-specific detergents and rinse aids.

  1. Detergent: Fill main cup only (do not overfill). Use tablets, powder, or gel.
  2. Pre-wash cup: Add small amount of detergent for heavily soiled loads.
  3. Rinse aid: Fill dispenser until indicator shows FULL; adjust dispenser setting (1-6) based on water hardness.
  4. Detergent types: Tablets (all-in-one), Powder (adjustable amount), Gel (pre-measured).
  5. Special additives: Use dishwasher cleaner monthly to remove buildup.

  WARNING! Do not use hand dish soap, laundry detergent, or bleach pods. Can cause excessive suds and damage.

  Care & Maintenance

  Regular maintenance ensures optimal performance and longevity.

  1. Clean filter: Remove and rinse filter weekly (for manual clean models).
  2. Check spray arms: Ensure holes are not clogged; rotate freely.
  3. Wipe door gasket: Clean with damp cloth to maintain seal.
  4. Run monthly cleaner: Use dishwasher cleaning tablet or vinegar rinse.
  5. Inspect drain hose: Ensure no kinks or clogs.

  CAUTION! Unplug dishwasher before performing any maintenance. Do not use abrasive cleaners on interior.

  Regulatory Information

  UL Listed: Meets safety standards for household appliances. Energy Star: Certified models meet energy efficiency guidelines. FCC Part 15: Class B digital device; complies with interference limits. Copyright © Kenmore; trademarks of Sears Brands, LLC. For support, visit www.kenmore.com or contact 1-800-469-4668.

  Troubleshooting

  Symptom	Possible Cause	Corrective Action
  Dishwasher won't start	Door not latched, child lock on, no power	Ensure door closed securely; check child lock status; verify power outlet.
  Poor cleaning results	Spray arms blocked, incorrect detergent, low water temp	Clear spray arm obstructions; use proper detergent; ensure water heater set to 120°F+.
  Water not draining	Clogged filter, drain hose kinked	Clean filter; straighten drain hose; check garbage disposal connection.
  Leaking water	Overloading, damaged door gasket, loose connections	Redistribute load; inspect and clean door seal; check water line connections.
  Unusual noises	Foreign objects in pump, spray arm hitting dishes	Check for debris in pump area; rearrange load to prevent interference.
  Detergent not dispensing	Dispenser clogged, wet detergent caking	Clean dispenser cup; ensure detergent stays dry before cycle start.
  Spots on dishes	Hard water, rinse aid empty, incorrect loading	Refill rinse aid; increase rinse aid setting; ensure proper water heating.

  Reset: Unplug for 1 minute or turn off circuit breaker for 30 seconds to reset control board.

  Service: 1-800-469-4668; www.kenmore.com

  Kenmore Dishwasher User Manual © - All Rights Reserved 2025