Kenmore Elite Refrigerator Manual Model 795

The Kenmore Elite Refrigerator Model 795 is a premium French door refrigerator featuring advanced temperature management, a dual evaporator cooling system, adjustable spill-proof glass shelves, humidity-controlled crispers, a fingerprint-resistant stainless steel finish, external water and ice dispenser, and energy-efficient LED lighting. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water Line 7. Using the Ice & Water Dispenser 8. Temperature Management 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: French door design with bottom freezer, external ice and water dispenser, dual cooling systems, adjustable interior features, and electronic controls.

FeatureDescription
Dual Evaporator CoolingSeparate cooling systems for fridge and freezer to prevent odor transfer
External Ice & Water DispenserDispenses filtered ice and water through the door
Adjustable Spill-Proof ShelvesGlass shelves that contain spills and can be repositioned
Humidity-Controlled CrispersPreserve freshness of fruits and vegetables
Fingerprint-Resistant FinishStainless steel exterior that resists smudges
LED Interior LightingEnergy-efficient, bright lighting for better visibility
Temperature ControlsElectronic controls for precise temperature management
Door AlarmAlerts if door is left open
Power Saver ModeReduces energy consumption
Ice MakerProduces ice automatically and stores in bin

Installation

Unpack and inspect contents. Ensure proper location and clearances.

  1. Position refrigerator: Allow at least 2 inches clearance on sides and back for ventilation.
  2. Level the unit: Adjust front leveling legs to ensure doors close properly.
  3. Connect water line: Use 1/4-inch copper tubing or approved water line kit.
  4. Plug into dedicated 115V AC, 60Hz grounded outlet.
  5. Allow 24 hours for cooling system to stabilize before loading food.

WARNING! Refrigerator is heavy; use two people for moving. Ensure water line connections are tight to prevent leaks.

First-Time Setup

Power on refrigerator; follow initial setup procedures.

  1. Set temperatures: Default is 37°F for fridge, 0°F for freezer. Adjust using control panel.
  2. Activate ice maker: Lift the wire signal arm to ON position.
  3. Flush water system: Dispense and discard first 2 gallons of water.
  4. Install water filter: Insert and flush according to filter instructions.
  5. Configure features: Set door alarm, power saver mode, and other preferences.

CAUTION! Do not overload shelves. Allow space between items for proper air circulation.

Specifications

Controls and Settings

Access controls via the electronic panel on the dispenser or inside the refrigerator.

Control Panel: Temperature settings, filter reset, ice type selection, door alarm, power saver, lock controls.

Temperature Settings: Fridge (34-46°F), Freezer (-5 to 5°F). Ice Options: Cubed, crushed, or off. Filter Indicator: Lights when filter needs replacement (approximately every 6 months). Door Alarm: Sounds after 3 minutes if door is ajar. Control Lock: Prevents accidental setting changes.

Connecting Water Line

Required for ice maker and water dispenser operation.

  1. Turn off main water supply.
  2. Connect approved water line to cold water pipe using saddle valve or compression fitting.
  3. Route line to refrigerator connection at bottom rear.
  4. Connect to refrigerator inlet valve and tighten.
  5. Turn on water and check for leaks.
  6. Flush line before connecting to refrigerator.

Tip: Use copper tubing or FDA-approved plastic water line. Avoid kinks in the line.

Using the Ice & Water Dispenser

Dispenses filtered ice and chilled water.

  1. Select ice type: Press CUBE or CRUSHED button on control panel.
  2. Dispense ice: Press glass against ice dispenser lever.
  3. Dispense water: Press glass against water dispenser lever.
  4. Change filter: When FILTER light illuminates, replace EveryDrop® Filter 4.
  5. Reset filter indicator: Hold FILTER button for 3 seconds after replacement.
  6. Clean dispenser area: Wipe with soft, damp cloth regularly.

WARNING! Do not use with containers that cannot withstand pressure. Keep children away from dispenser.

Temperature Management

Dual cooling system maintains optimal temperatures separately for fridge and freezer.

Recommended Settings: Refrigerator: 37°F, Freezer: 0°F. Adjust based on load and ambient temperature. Power Saver Mode: Reduces condensation in humid environments. Door Alarm: Activated by default; can be disabled in settings. Temperature Alarm: Sounds if temperatures rise above safe levels.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and warm water for cleaning.

  1. Exterior: Clean with stainless steel cleaner and soft cloth.
  2. Interior: Remove shelves and drawers; wash with mild detergent.
  3. Condenser coils: Vacuum every 6-12 months for efficiency.
  4. Water dispenser: Clean tray and area with vinegar solution monthly.
  5. Ice maker: Empty and clean ice bin every 1-2 months.

CAUTION! Do not use abrasive cleaners or sharp objects. Never steam clean.

Regulatory Information

UL Listed: Complies with UL Standard 250. FCC Part 15: Class B digital device. Energy Star: Meets EPA energy efficiency guidelines. Copyright © Kenmore; trademarks of Sears Brands, LLC. For support, visit www.kenmore.com or contact 1-800-469-4668.

Troubleshooting

SymptomPossible CauseCorrective Action
Refrigerator not coolingPower/controlsCheck power connection; ensure temperature settings correct; clean condenser coils.
Ice maker not workingWater supply/filterEnsure water line connected and turned on; check filter; verify ice maker arm is in ON position.
Water dispenser slowFilter/kinked lineReplace water filter; check for kinks in water line.
Excessive frost in freezerDoor seal/temperatureCheck door seals for gaps; ensure door closes completely; verify temperature setting.
Unusual noisesLeveling/fanEnsure refrigerator is level; check for items touching fan; clean condenser fan.
Control panel not respondingPower/child lockCheck power supply; disable control lock; reset by unplugging for 5 minutes.

Reset: Unplug for 5 minutes, then reconnect to reset electronic controls.

Service: 1-800-469-4668; www.kenmore.com

Kenmore Elite Refrigerator Manual Model 795 © - All Rights Reserved 2025