Kenmore Elite Stove Manual Model Number

The Kenmore Elite stove is a high-performance kitchen appliance featuring advanced cooking technology, multiple oven modes, precise temperature control, durable construction, and user-friendly digital controls. This manual covers essential information for safety, features, installation, operation, maintenance, and troubleshooting specific to your model number. Always verify your exact model number (typically located on a label inside the door frame or on the back) before proceeding.

1. Features at a Glance 2. Installation & Setup 3. Specifications 4. Controls & Display 5. Cooking Modes & Functions 6. Connecting to Power & Gas 7. Cleaning & Maintenance 8. Safety Features 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Digital control panel, oven cavity, bake/broil elements, convection fan (if equipped), storage drawer, cooktop burners or heating elements, door lock mechanism, and temperature probe.

Feature	Description
Model Number Label	Located inside door frame or on rear panel for identification
Digital Control Panel	Touchpad with LCD display for settings and timers
Convection Oven	Circulates hot air for even cooking (on select models)
Self-Cleaning Cycle	High-heat pyrolytic cleaning function
Cooktop	Gas burners or electric heating elements
Oven Light	Interior illumination switch
Storage Drawer	For pans and cookware (not a warming drawer on all models)
Temperature Probe	For precise meat/internal temperature cooking
Child Safety Lock	Locks control panel to prevent accidental activation
Delay Start Timer	Program oven to start at a later time

Installation & Setup

Unpack and inspect all parts. Ensure proper location with adequate clearance and ventilation.

Verify electrical/gas requirements: Check rating plate (voltage, amperage, gas type).
Position stove: Level using adjustable feet; ensure anti-tip bracket is installed (if included).
Connect power/gas: For electric, connect to dedicated outlet/circuit. For gas, use flexible connector and check for leaks with soap solution.
Initial setup: Plug in, turn on circuit breaker/gas valve. Set clock and confirm model number.

WARNING! Installation must be performed by a qualified technician. Improper installation can cause fire, electric shock, or gas leak.

Specifications

Model Series: Kenmore Elite (specific model number varies).
Oven Capacity: Standard or large capacity (check model spec).
Fuel Type: Natural Gas (NG) or Liquid Propane (LP) for gas models; Electric for coil/smooth-top.
Power Requirements (Electric): 120V/240V, 60Hz, dedicated circuit.
Burner Output (Gas): Varies by model (e.g., 5,000 to 18,000 BTU).
Control Type: Electronic touchpad with digital display.
Cleaning System: Self-cleaning (pyrolytic) or continuous cleaning options.
Warranty: Limited 1-year parts and labor; check registration card.

Controls & Display

Access functions via the digital control panel. Front Panel: POWER/STANDBY, CLOCK/TIMER, OVEN MODE, TEMPERATURE/TIME adjustment arrows, CLEAN, LOCK, LIGHT.

Display Icons: Clock, timer, oven temperature, cook time, delay start, lock symbol, error codes.

Oven Settings: BAKE, BROIL, CONVECTION BAKE, CONVECTION ROAST, WARM, PROOF, SELF CLEAN. Cooktop: Individual burner controls (knobs or touch). Advanced: Delay Start, Kitchen Timer, Sabbath Mode (on some models).

Cooking Modes & Functions

Supports various cooking methods for optimal results.

Preheat: Select mode (e.g., BAKE), set temperature, press START.
Bake: Standard heating from bottom element.
Broil: High heat from top element (door should be slightly ajar for gas models).
Convection: Uses fan to circulate air; may require temperature or time adjustment.
Warm/Proof: Low temperature for keeping food warm or dough rising.
Self-Clean: Engage lock; cycle runs 2-4 hours at high temperature. Ensure kitchen is ventilated.
Delay Start: Set cook time and end time; oven starts automatically.

Tip: Refer to cooking charts in manual for recommended temperatures and times.

Connecting to Power & Gas

Electric: 4-prong or 3-prong cord (check local codes). Gas: Flexible connector with shut-off valve.

Turn off main power/gas supply before installation.
Electric: Connect wires to terminal block (L1, L2, N, G).
Gas: Apply pipe thread sealant; tighten connections; check for leaks.
Verify operation: Turn on supply; ignite burners; test oven heating.

CAUTION! Gas connections must be leak-tested. Do not use if smell of gas is present.

Cleaning & Maintenance

Unplug or turn off gas before cleaning. Use mild detergent and non-abrasive cloth.

Daily: Wipe control panel and cooktop with damp cloth.
Interior: Clean spills after oven cools. Use oven cleaner for non-self-clean models.
Self-Clean: Remove racks and large debris; engage cycle; wipe ash after cooling.
Burners/Elements: Remove and clean according to type (soak gas burners; wipe electric coils).
Door: Clean glass with oven glass cleaner; do not immerse door in water.

WARNING! Never use oven cleaners on self-cleaning surfaces. Keep control panel dry.

Safety Features

Child Lock: Press and hold LOCK for 3 seconds. Door Lock: Automatically engages during self-clean. Overheat Protection: Thermal cutoff shuts off elements if overheated. Cooktop Burner Ignition (Gas): Automatic spark or glow bar ignition with safety valve.

Regulatory Information

UL/CSA listed for USA/Canada. Complies with ANSI Z21.1 (gas) or UL 858 (electric). Manufactured for Sears Brands, LLC. Copyright and trademarks owned by Sears. For support, locate your model number and visit www.kenmore.com or call 1-800-469-4668.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Oven not heating	Power/gas supply, control settings	Check circuit breaker/gas valve; ensure proper mode/temp selected; verify model number for specific wiring.
Uneven cooking	Rack position, convection fan	Use recommended rack position; ensure convection fan is running (if equipped).
Control panel unresponsive	Child lock, power interruption	Disengage child lock; unplug for 1 minute to reset; check for error codes.
Gas burner won't ignite	Clogged ports, igniter issue	Clean burner ports; check for spark at igniter; ensure gas supply is on.
Self-clean not starting	Door not locked, excessive debris	Ensure door is fully closed and locked; remove large food spills before cycle.
Error code displayed (e.g., F1, F2)	Sensor/control fault	Note code; unplug for 5 minutes; if persists, contact service with model number.

Reset: Turn off power at breaker for 1 minute to reset electronic controls.

Service: 1-800-469-4668; www.kenmore.com. Have model number ready.