Kenmore Refrigerator 795.69009.900 Manual

The Kenmore 795.69009.900 is a side-by-side refrigerator with through-the-door ice and water dispenser, adjustable glass shelves, humidity-controlled crispers, gallon door storage, and a factory-installed ice maker. It features electronic temperature controls, energy-saving mode, door alarm, and a filtered water system. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Using the Dispenser 7. Temperature Management 8. Care & Cleaning 9. Filter Replacement 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Side-by-side doors, Ice and Water Dispenser, Adjustable Shelves, Humidity-Controlled Crispers, Gallon Door Bins, Electronic Controls, Air Filter, Water Filter.

Feature	Description
Through-the-Door Dispenser	Provides ice and filtered water without opening the door
Adjustable Glass Shelves	Customizable storage space; easy to clean
Humidity-Controlled Crispers	Preserves freshness of fruits and vegetables
Gallon Door Storage	Holds large containers like milk jugs
Factory Ice Maker	Automatically produces ice; stores in bin
Electronic Temperature Controls	Digital display for fridge and freezer settings
Door Alarm	Alerts if door is left open
Energy Saver Mode	Reduces power consumption
Water Filter Indicator	Light alerts when filter needs replacement
Power Cord	Standard 120V, 60Hz plug

Installation

Unpack and inspect contents. Ensure proper clearance for doors and ventilation.

Position refrigerator: Place on level floor with at least 2 inches clearance on sides and back.
Connect water line: Attach to cold water supply using included kit; ensure no leaks.
Plug into dedicated outlet: Use 120V AC, 60Hz grounded outlet.
Allow stabilization: Let unit stand upright for 2 hours before powering on.

WARNING! Refrigerator is heavy; use two people for moving. Ensure water line is securely connected to prevent leaks.

First-Time Setup

After installation, power on and configure initial settings.

Set temperatures: Press TEMP buttons to set fridge to 37°F and freezer to 0°F.
Enable ice maker: Lift the wire signal arm to start ice production.
Flush water system: Dispense 2 gallons of water to clear air from lines.
Adjust shelves and bins: Arrange for optimal storage.
Activate features: Set door alarm and energy saver as desired.

CAUTION! Do not overload shelves. Allow 24 hours for temperatures to stabilize.

Specifications

Model: 795.69009.900
Type: Side-by-Side Refrigerator
Total Capacity: 25 cubic feet
Ice Maker: Automatic, built-in
Dispenser: Ice and filtered water through door
Shelves: Tempered glass, adjustable
Controls: Electronic with digital display
Filter: Replaceable water filter (every 6 months)
Power: 120V AC, 60Hz, 7.5 amps
Dimensions (HxWxD): 70" x 36" x 34"

Controls and Settings

Control panel located on the front dispenser area. Buttons: TEMP (Fridge/Freezer), LOCK, FILTER RESET, ENERGY SAVER, ALARM.

Temperature Settings: Use TEMP buttons to adjust (34°F to 46°F for fridge, -5°F to 5°F for freezer). Dispenser Lock: Press and hold LOCK for 3 seconds to disable dispenser. Filter Reset: Press FILTER RESET after replacing filter. Energy Saver: Press to reduce condensation in humid environments. Door Alarm: Sounds after 3 minutes if door is ajar; press ALARM to silence.

Using the Dispenser

Dispenser provides ice (cubed or crushed) and filtered water.

Select ice type: Press CUBE or CRUSH button.
Dispense ice: Press lever against glass.
Dispense water: Press water lever.
Child lock: Enable to prevent accidental dispensing.

Tip: First use may take 24 hours for ice production. Ensure water line is connected and on.

Temperature Management

Maintain optimal temperatures for food safety and efficiency.

Monitor: Check digital display for current temps.
Adjust: Use TEMP buttons; wait 24 hours between adjustments.
Energy Saver: Use in low-humidity areas to save power.
Door Alarm: Ensure doors close completely to avoid temperature rise.

WARNING! Do not block air vents inside refrigerator. Keep freezer at least ¾ full for best efficiency.

Care & Cleaning

Unplug before cleaning interior. Use mild soap and water; avoid abrasives.

Exterior: Wipe with damp cloth; dry immediately.
Interior: Remove shelves and bins; wash with warm soapy water.
Dispenser: Clean with soft cloth; run water to flush debris.
Condenser coils: Vacuum every 6 months (located at back or bottom).

CAUTION! Do not use harsh chemicals or steam cleaners. Never clean glass shelves with hot water if cold.

Filter Replacement

Replace water filter every 6 months or when indicator light turns on.

Locate filter: Inside refrigerator compartment, upper right corner.
Turn old filter counterclockwise to remove.
Insert new filter (remove protective caps); turn clockwise until it stops.
Flush: Dispense 2 gallons of water to clear air.
Reset: Press and hold FILTER RESET for 3 seconds.

Note: Use only Kenmore filter part #469906 to ensure compatibility.

Regulatory Information

UL Listed; complies with U.S. safety standards. Energy Star certified. Manufactured for Sears Brands, LLC. Copyright © Kenmore. For support, visit www.kenmore.com or contact 1-800-469-4663. Model 795.69009.900.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Dispenser not working	Lock activated/child lock	Disable lock; ensure door is closed fully.
Water tastes odd	Old filter	Replace water filter; flush system.
Ice maker not producing	Signal arm down/water supply	Lift signal arm; check water line connection.
Temperature too warm	Settings/blocked vents	Adjust temperature; clear items blocking vents.
Excessive frost in freezer	Door seal/defrost system	Check door seal; ensure defrost cycle runs.
Loud noises	Leveling/ice maker	Level refrigerator; ice maker noises are normal during cycle.

Reset: Unplug for 5 minutes to reset electronic controls.

Service: 1-800-469-4663; www.kenmore.com