Kenmore Series 600 Washer Manual

The Kenmore Series 600 is a high-efficiency top-loading washing machine featuring multiple wash cycles, adjustable settings, and energy-saving technology. Designed for reliable performance and ease of use, it includes options for load size, water temperature, soil level, and spin speed. Below are key sections for safety, features, installation, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Control panel with digital display, agitator, stainless steel wash basket, water inlet valves, drain pump, and adjustable leveling legs.

Installation

Unpack and inspect contents. Place on level floor near water supply and drain.

1. Remove shipping materials: Take out transit bolts and packing materials.
2. Level the washer: Adjust front leveling legs to ensure machine is stable.
3. Connect water supply: Attach hot and cold water hoses to corresponding faucets.
4. Connect drain hose: Secure drain hose to standpipe or laundry tub.
5. Plug into grounded electrical outlet.

WARNING! Washer is heavy; use two people for moving. Ensure all connections are secure to prevent leaks.

First-Time Setup

After installation, run an initial cleaning cycle.

1. Power on washer: Plug in and press POWER button.
2. Run cleaning cycle: Select "Clean Washer" cycle or run a hot water cycle with bleach (no clothes).
3. Set preferences: Use OPTIONS button to set default signal volume, child lock, etc.
4. Test operation: Run a small load to ensure proper functioning.

CAUTION! Do not use washer without removing shipping bolts. Ensure water supply valves are fully open.

Specifications

• Capacity: 4.5 cubic feet.
• Dimensions: 27" W x 27" D x 43" H.
• Voltage: 120V AC, 60Hz.
• Water Connections: Hot and cold water inlet hoses (5/8").
• Max Spin Speed: 700 RPM.
• Cycle Time: Varies by cycle (15 min to 60 min).
• Noise Level: Less than 65 dB during spin.
• Warranty: 1-year limited parts and labor.
• Weight: 150 lbs.

Controls and Settings

Access settings via control panel buttons and dial.

Control Panel: POWER, CYCLE SELECTION KNOB, START/PAUSE, OPTIONS, CHILD LOCK, SIGNAL.

Cycle Settings: Select cycle with knob (Normal, Heavy Duty, Delicates, Quick Wash, Bulky Items). Options: Press OPTIONS to adjust load size, water temp, soil level, spin speed, and delay start. Display: Shows cycle time, settings, and error codes. Child Lock: Hold CHILD LOCK for 3 seconds to enable/disable. Signal: Press SIGNAL to turn end-of-cycle beep on/off.

Connecting Water Supply

Hot and cold water connections required for full functionality.

1. Turn off water supply before connecting hoses.
2. Connect hot hose to hot water faucet (usually left side).
3. Connect cold hose to cold water faucet (usually right side).
4. Hand-tighten connections; avoid over-tightening.
5. Turn on water supply and check for leaks.

Tip: Use only new hoses; replace hoses every 5 years to prevent failure.

Using Wash Cycles

Supports various fabrics and soil levels.

1. Load clothes: Do not overload; leave space for agitation.
2. Add detergent: Use HE detergent; follow manufacturer's instructions.
3. Select cycle: Turn knob to desired cycle.
4. Adjust settings: Use OPTIONS to set load size, water temp, soil level, spin speed.
5. Start: Press START/PAUSE; display shows remaining time.
6. Pause: Press START/PAUSE to pause; press again to resume.
7. Add garment: Press START/PAUSE to pause; lid unlocks after agitation stops.
8. Delay start: Press OPTIONS, select DELAY START, set hours (1-24).

WARNING! Do not open lid during spin cycle. Balance load to prevent excessive vibration.

Special Features

Delay Start: Program wash to begin later. Child Lock: Prevents changes during cycle. Signal: Audible alert when cycle ends. Deep Fill: Extra water option for heavily soiled loads. Quick Wash: 15-minute cycle for lightly soiled items.

Care & Cleaning

Unplug before cleaning. Wipe exterior with damp cloth. Clean lint filter monthly. Run "Clean Washer" cycle monthly with washer cleaner or bleach.

CAUTION! Do not use abrasive cleaners. Keep control panel dry. Clean drain pump filter if draining issues occur.

Regulatory Information

UL Listed; complies with U.S. safety standards. ENERGY STAR® certified. Copyright © Kenmore; trademarks of Sears Brands, LLC. For support, visit www.kenmore.com or contact 1-800-469-4668.

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: 1-800-469-4668; www.kenmore.com